When the load pressure and the setting pressure of the safety valve are close to each other, the jacking oil circuit of 2 can be simplified into the throttling speed regulating circuit of the side oil circuit. The mechanical characteristic equation of the circuit <1> can be expressed as TP=HPTA1-KPFA21GM-KAA1 (FA1GCM) M (1) circuit stiffness can be expressed as TP=-9F9TP=A21GCMKP+KAM (FA1GCM) M-1 (2) side oil circuit throttle speed regulation circuit diagram there is only one high-pressure relief valve in the descent process So it does not have the ability to speed. The control of descending speed is completely controlled by closed-loop control oil circuit composed of externally controlled balancing valve and load cylinder. If the output of the oil pump is taken as the input signal and the falling speed of the cylinder is taken as the output, the typical transfer function of the externally controlled balance valve <2>T (S) H (S) =KQ (T210S2+2T10N10S+1) (T12S+1) (T13S+1) (T211S2+2T11N11S+1) can be obtained. The balance valve control loop of traditional oil circuit consists of two inertial links, one second-order differential link and one oscillation link. The maximum speed of the circuit depends on the output of the oil pump H (S), the key to the smooth speed is to improve the quality of the balance valve, so that the inertial link is resolved, and the oscillation link is rapidly attenuated, that is to say, the decline speed characteristics of the oil circuit in Figure 1 depends on the quality of the balance valve.

